 |
 |
 |
Step 1
Hold the base of the bush next to the tip section and calculate where
to cut.
|
Step
5
Place the end bung in the end of the second section. A slight twist
will mark the bung ready for cutting.
|
Step
9
Pull the elastic back through the entire top kit until it appears from
the bush. Hold the elastic and remove threader.
|
 |
 |
 |
Step 2
Cut finer than you need to with a hacksaw moving down at one inch
intervals until the bush is a tight fit.
|
Step
6
Cut the bung slightly smaller than your mark with a hacksaw or craft
knife.
|
Step
10
Place the end cap of the connector on first and then tie on the main
body with a double overhand loop knot.
|
 |
 |
 |
Step 3
Remove all rough edges with a file or emery paper.
|
Step
7
Push the diamond eye threader through from the tip end.
|
Step
11
Tie the bung on at the base end forming a 12" loop. This will
help when playing larger fish.
|
 |
 |
 |
Step 4
Push the bush on. If correct the bush should not need gluing.
|
Step
8
Trap around 2" of elastic in the small kink in the end of the
threader, making sure it is secure.
|
Step
12
Check the elastic and if necessary retie the connector until the
correct tension is achieved.
|
